Dantherm HCC 260 P1 Service Manual page 21

Cable installation
Connecting to LAN
MODBUS
Antenna
22
Pull the cable through the sheet metal plate next to the 230V AC input. This can either be on
the right or the left. See more at page 14
Press the cable in between the sheet metal and the EPS part.
Connect the unit to LAN using a standard Ethernet cable, fitted with RJ45 plug.
If using non pre-fabricated cable, please first run the cable through the house as needed and
mount the RJ45 plug using the standard Ethernet wire crossing terminology, as specified in
T568B. These mounting instructions can be found in the internet fx. on Wikipedia.
The unit will be accessible for the smartphone app (IOS and Android), if your device is con-
nected to the same network via WIFI.
IP adress Description
allocation status
Dynamic IP If the unit is connected to a router with built-in DHCP server it will
fetch the IP address itself from the router when the unit starts up.
Static IP Using PC Tool it is possible to allocate a static IP address to the unit,
which is necessary for example in order to perform checks on HCC
260/360 via smartphone app when outside the LAN's range. This will
also require setup of the home's WAN address as well as allocating a
port on the router.
MODBUS:
MODBUS RTU is only for internal communication between unit (UVC print) and Dantherm
accessories (HAC, FPC, or HCP11)
Connected via RS485 port
Important! External BMS can not be connected as a Modbus RTU via RS485 port, nor via
Dantherm accesso-ries . (HAC, FPC, or HCP11)
Modbus TCP/IP
The controllers in the Dantherm ventilation units has the possibility to communicate Mod-
bus TCP/IP over the Ethernet port. This is used for Building Management Systems (BMS) or
communication with smartphone apps.
External antenna can be connected here, to gain higher coverage area.
Installation : Connecting additional equipment
Fig. 24