Weston 07-1201-W Manual page 7

Entanglement Hazard: To avoid serious injury do not reach
w WARNING
into grinder inlet. Always use stomper.
8. At this point you can attach the Tomato Press
& Sauce Maker to your work space. If utilizing
the Suction Cup (7), be sure the area you wish to
adhere to is smooth, clean, and dry. Simply raise
the Suction Cup Lever (13) and hold the Tomato
Press & Sauce Maker firmly in place with the
Suction Cup (7) in contact with the table surface,
then press the Suction Cup Lever (13) down. The
Suction Cup Lever will require firm pressure to
lock it into place. NOTE: If you have a rough or
dirty surface, the Suction Cup may not adhere to
the surface.
9. If utilizing the C-Clamp (8), simply position the
Tomato Press & Sauce Maker near the edge
of a table or counter. Slide the top end of the
C-Clamp into the slot at the base of the Tomato
Press & Sauce Maker and tighten the screw to
the underside of the work surface.
10. Slide the Handle (10) into the Tomato Press
& Sauce Maker making sure to align the slots in
the Drive Shaft (5) to the tabs on the Handle.
11. Attach the Waste Funnel (16) to the end of
the Screen (15) by pushing the small end with
the tabs over the end of the Screen. NOTE: Use
caution not to break the Waste Funnel when
attaching or detaching.
12. Attach the Chute Assembly (12) to the
Screen by sliding the lower half of the assembly
under the Screen (15). Securing the underside,
insert the hinges of the upper half of the
assembly into the lower half. Once in place, snap
the wire clamp in place. The Chute Assembly
should be positioned so that it covers the Screen
in its entirety. FIGURE F
13. Attach the Hopper (1) to the top of the
Strainer by sliding the small neck section of the
Hopper into the throat of the Body (2).
14. Before placing any food in the Hopper (1)
be sure to have a bowl or jar under both the
Waste Funnel (16) and the Squirt Guard/Chute
(12). FIGURE G
12
FIGURE F
6
15
7
1
FIGURE G
16
12
1
7