Epson S5U1C17000Y23 System Manual page 24

6. Gang Writer Configuration
Error Message
Please check all items.
Over useful range. Check ID No.
There are the same as "ICDmini Serial No."
item two or more.
There are the same as "ID No." item two or
more.
Please set load parameter information.
Can not found Parameter file.
Parameter file error.
Following characters of parameter file are
not allowed to used.
/;,*?<>|"
18
Table 6.4.1 List of Error Messages
No target system to be programmed is found. Make sure that the ICDmini is
connected to the PC correctly and then click on the [DETECT] button to get
the connected ICDmini recognized before clicking the [LOAD START]
button.
One or more values entered in the [ID No.] fields exceed the effective
range. The ID No. must be within the range from 0 to 999.
Two or more ICDminis have the same serial number. Refer to "5.4
Confirming ICDmini Hardware Version and Programming Serial Number"
and reconfigure the ICDminis with a unique serial number.
Two or more [ID No.] fields have the same number entered. Change them
to a unique number.
The [Parameter File] field is empty and the parameters have not been
configured in the [Set Load Parameter] dialog box yet. Refer to "6.2 Setting
Gang Writer Parameters" and fill in the parameter fields.
The parameter file specified in the [Parameter File] field cannot be found.
Use the [Browse] button to specify the parameter file. Refer to "6.4 Loading
Program to ICDmini."
There is an error in the contents of the parameter file. Refer to "6.2 Setting
Gang Writer Parameters" and correct the illegal parameter value.
One of the characters shown below is included in the parameter file name.
/ ; , * ? < > | "
Do not use these characters for the parameter file name.
Seiko Epson Corporation
Description
S5U1C17001Y23 Multi-Programmer
System Manual (Rev. 1.1)