Table of Contents
Advertisement
5. Ensure that the power switch on the AC power adapter is in the OFF position (O). Plug
the DC barrel connector on the AC power adapter into the power port on the right side
of the printer. Plug the included AC power cable into the AC power adapter, then plug
the other end into a nearby AC power outlet.
6. Flip the power switch on the AC power adapter to the ON position (I). After the printer
finishes booting, you will see the following wizard. Press the knob on top of the printer
to select [Next] on the Welcome screen, then again to select [Next] on the [STEP 1:
LOAD FILAMENT] screen.
7. Using a pair of scissors or side cutters, cut about an inch off the end of the filament,
then gently straighten the end of the filament. Squeeze the lever on the extruder,
insert the filament from the bottom until you encounter resistance, then release the
lever.
Installation
6
Advertisement
Table of Contents
