Controls - Jetline 9600 Series Operation Manual

9629 Microprocessor Controller
Section V.

Controls

The push-button power switch is used
to provide primary power to the 9629
control. The first press of the switch
turns on the control. The screen will
POWER
become active and display the start-up message.
A second press of this push-button switches the
control off.
These two touch pads are used to
UP
scroll the display up and down. The
down touch pad scrolls down the
display - this takes you through the
DOWN
various control options in a logical order. The
up touch pad is used to go back through the lines
of the display options. In the standard operating
mode of the 9629 control, these touch pads have
no other purpose.
The adjustment knob is used to change
the value which is currently displayed.
You will note that the knob "incre-
ments", each incremental movement
ADJUST
of the knob increases the value by its smallest
increment. If the knob is rotated quickly, you
will see that the numbers increase or decrease
faster. The knob can be used to preset the speed
before the motor starts or to change the speed
when the motor is running.
These two touch pads are used to
jog the wire in a reverse or forward
direction. When the touch pad is
REV
FOR
pressed, wire feed will begin in the direction
selected and will continue as long as the pad is
pressed. When the touch pad is released, wire
feed will stop. In addition to the jog facility
provided by the touch pads, they are capable of
providing two more functions.
Rapid Jog: This is achieved by pressing the
forward or reverse touch pad for a short time,
releasing it and then quickly pressing it again.
Wire feed will start and, after a short time, will
speed up to the "rapid" speed. Rapid wire feed
will continue until the touch pad is released.
Maintained Jog: This is achieved by first
pressing the forward or reverse touch pad and,
while still pressing this touch pad, pressing and
releasing the start button. The forward or reverse
switch can then be released. Wire will feed at
rapid speed until it is stopped by pressing the
stop button. This feature is useful for feeding
wire through the conduit after the wire spool has
been changed.
Depressing and releasing the start
push-button will start the weld se-
quence which will continue until
the stop or emergency stop button is
START
pressed. Pressing the start push-button while
the forward or reverse touch pad is pressed will
initiate maintained, rapid wire feed.
Depressing and releasing the stop
push-button will immediately stop
the wire feed.
STOP
The emergency stop push-button is a
large, red mushroom-headed switch
designed to stop all operations quickly
EMERGENCY
in the event of an emergency. When
STOP
pressed, the wire feed will be immediately
stopped and power will be removed from the
motor. To reactivate the system, the switch must
be reset by being pulled out. After reactivation,
wire feed must be restarted in the normal way
using the start button.
- 14 -