Section Iv Description - Jetline 9600 Series Operation Manual

Section IV
Description
The 9629 control is a microprocessor-based
control designed for the control of wire feed,
primarily for TIG and plasma welding. The
9629 is one of a series of controls designed for
ease-of-use and for accurate control of various
drive motors for different weld applications.
The 9629 is packaged in a conveniently-sized
enclosure with Amphenol connectors. The en-
closure has four mounting holes to permit it to
be fastened to the face of a travel carriage or to a
control podium. The front panel is a membrane
overlay with a backlit LCD display and switches
to control the setup and operation of the unit.
The 9629 control has been designed to be easy
to use. Its operation is made easier by the use of
the display which guides you through the setup
process and, during the welding sequence, tells
you what is happening.
UP
WIRE SPEED
DOWN
SERIES 9600 CONTROL
EMERGENCY
STOP
POWER START
9629 Microprocessor Controller
UP
DOWN
The display has two lines of text, the upper line
is the primary one. This is the line that is used
to set the value of the parameter you are setting.
This is done by calling up the line for the param-
eter required and then turning the adjust knob to
increase or decrease the value. The second line
is used to display status messages (information)
about the progress of the weld sequence to let
you know what stage the process is in. Most of
these messages are normally only displayed after
the start push-button has been pressed.
26.5ipm
ADJUST
REV
STOP
- 13 -
WIRE SPEED 26.5ipm
FOR
ADJUST