Weld Data Setting Menu; Measure Image - ESAB Aristo U8 Instruction Manual

GB
2.1.2

Weld data setting menu

In the WELD DATA
SETTING MENU you can SETTING MENU you can
change various weld
parameters. The menu's
appearance differs,
depending on which weld
process you have selected.
In this example it is
MIG/MAG welding with
dip/spray.
2.1.3

Measure image

In the MEASURE IMAGE
you can see the measured you can see the measured
values of various weld
parameters during welding.
The measured values
remain in the display even
after welding has been
completed.
You can move to other
menus without losing the
measured values.
The arrow in the bottom right--hand corner of the display indicates that there is more
information available.
In the measure image you can change the value of certain parameters. Which
parameters these are depends on which weld process has been set. The parameter
values that can be adjusted are always marked with # or *.
When values are changed while no welding is in progress, the measured values will
change to zero to avoid misunderstandings regarding which settings correspond to
the measure result.
TIP!
In pulsing you can select whether the voltage value is displayed as an average value
or peak value. This setting can be defined under MIG/MAG basic settings, see
chapter 12.3.
bi09dinte
WELD DATA SETTING
VOLTAGE:
WIRE SPEED:
INDUCTANCE:
SYNERGIC MODE
START DATA...
STOP DATA...
LIMITS
CRATR HOT
FILL START
DIP/SPRAY. Fe, CO2, 1.2 mm
#
*
CRATER HOT
FILL START
- - 12 - -
# 26.8 (+0.0) V
* 6.0 m/min
80 %
PÅ
4--
STROKE QUIT
0.0 Volt
0 Amp
6.0 m/min
4--
STROKE REM
↓
2ND
FUNCT