Dry Ironing - Swann Ceramic Series Manual

How to use your steam generator
5. During steam ironing, please adjust steam rate according to your requirement as
indicated in the steam function setting.
6. After use, Set the temperature control dial to "MIN" position, and place the iron
back on the iron rest plate. Switch off the unit by pressing the power switch and
then unplug the appliance from the outlet.
7. Slide out the water tank and pour out the remaining water.
Note:
a. For every first time use, it is normal that a slight vibration sound may be
heard from electrical pump inside the base unit for about 10 seconds when
steam ironing started. It is because there is air inside the filter, it will stop when the air
inside the filter has been pumped out. If this sound continues
for more than 30 seconds, please check whether water tank and filter are
assembled correctly or not.
b. During use, if steam stops along with 5 BEEP sound alarm, or
water tank indicator light and water filling indicator light on control
panel blink. This indicates that it is time to fill water tank.
c. For continous use of steam ironing, sometimes pump working indicator light will
turn off for several seconds,steam also will stop for several seconds. This is
normal. It is because anti-drip function has been activated to protect leakage from
soleplate.

Dry ironing

1. Connect the appliance to a suitable socket outlet. Press power switch on control
panel, a Beep sound will be heard and the power indicator light lights up. It
shows that the unit has been connected to the power supply.Press steam selection
switch to turn off all 3 steam indicator lights ,it is ready for dry ironing.
2. Set temperature control dial to desired position according to above fabric setting
chart. Temperature indicator light in iron unit will light up to indicate that the steam
chamber being heated up. When temperature indicator light turn off, it indicates
that desired temperature has been reached ,it is ready for dry ironing. During use,
it is normal that heating indicator light will cycle from on to off, and then off to on.
This shows that steam chamber automatically keeps temperature constant.
3. During use,please press steam lock every 15 minutes. Otherwise, iron will
automatically shut off.(Refer to auto-shut off function).
4. After use, Set the temperature control dial to "MIN" position, and place the iron
back on the iron rest plate. Switch off the unit by pressing the power switch and
then unplug the appliance from the outlet.
Note:
When changing your Temp setting from higher setting to lower, it is advised
not to start ironing immediately since it may cause burns to your fabrics.
Please wait until temperature indicator light lights up steadily,
and then start ironing.
8