Steam Ironing - Swann Ceramic Series Manual

How to use your steam generator
Functions for Water tank indicator light
1. After power On, water tank indicator light will light up. Water tank
indicator light blinks to show that no water or not enough water is in the
tank, please fill water to Max level. After filling with water, water tank indicator
light will light up steadily for easy viewing of water level.
2. Water tank indicator light will not light up when water tank or filter are
not properly in place and no steam function even if steam button is pressed.
"BEEP" sounds from base unit if tank or filter are not properly fitted.
Steam function setting:
Once the unit energised with power, steam indicator light automatically sets at
low steam setting. Press steam selection switch to change to MAX or Medium steam
setting. If steam ironing is not necessary, please turn off the steam selection switch,
and wait for all steam indicator light to go out.

Steam ironing

1. Fill water tank with clean water refer to above filling instruction. For better
performance, please immerse filter in water for several minutes before installing it into
the water tank.
2. Connect the appliance into a suitable socket outlet. Press power switch on control
panel, a Beep sound and the power indicator light illuminates, it
shows that the unit has been connected to the power supply. Water
tank indicator light will also light up. Heating indicator light will turn on to
indicate that the steam chamber being heated up. Low steam setting indicator light
turns on to indicate steam is set at low setting. During use, it is normal that heating
indicator light will cycle from on to off. This shows that steam chamber
automatically keeps temperature constant.
3. Set temperature control dial to steam ironing position according to fabric setting
chart mentioned above. Heating indicator light at iron unit turns on to indicate the
unit being heated up. When the heating indicator light turn off ,the desired
temperature has been reached. It is ready for steam ironing.
4. Before every first time use, it is advised to clean iron unit as follows:
Take the iron up from the base unit, press steam button underneath the handle to
allow steam ON for 20 seconds, and then OFF for 30 seconds, this cycle should
be repeated for 2 times. Wait until temperature indicator light turn off, it is ready for
use.
7