Ironing Tips - Swann SI11010N User Manual

DRY IRONING
If the garment requires dry ironing then don't press the steam release button during
ironing. There are some lower temperature settings eg NYLON where steam function
is not available, since the soleplate doesn't get hot enough to produce steam at his
temperature
If you are unsure about the correct setting for your iron or if the garment label is
missing then try ironing a small inconspicuous area of the garment first.
TANK LEVEL
The tank should hold enough water to fuel even the longest ironing session but keep
your eye on it. It's always best to refill the tank before it becomes completely empty. If
the pump noise increases, it is a sure sign that the tank is empty!
After refilling the tank, you may need to prime the pump again. Hold the hand unit
below the base and press/hold the steam release button. It should only take a few
seconds to prime the pump - and you're ready to go again!
If you need to refil the tank more than twice during a single ironing session, then some
pondering on the life choices you have made that have lead to the existential horror
of having such a back log of ironing to do might be in order (our service line cannot
help with this).
VERTICAL STEAM IRONING
• Follow the steam ironing process, and then hold
the iron in vertical position about 5cm to 15cm
away from the hanging fabrics. Press the steam
release button, which will create vertical steam.
• This feature is especially used for removing
creases from hanging clothes and curtains.
• Never directsteam toward people or animals
• The room should be ventilated.
• Note: Never block the steam hose.
SI11010N_IM.indd 7

IRONING TIPS

Fig.8
7
01/05/2014 11:34