Troubleshooting - Swann Ceramic Series Manual

Trouble shooting
Problems
Iron won't heat
Water tank
light blinks. Two
BEEP sounds alarm
when pressing
the steam button.
Droplets of water
escape from the
soleplate
Water tank
decoration indicator
light OFF
All indicator light
OFF
Iron does not
produce steam
Possible causes
Incorrect connection to the
main socket
Temperature setting knob is
set at O position.
Power OFF
Handle has not been laid down
Unknown malfunction.
No water or not enough water
in water tank.
Temperature control dial is set
at low temperature position.
The set temperature has not
been reached or is too low.
Steam is set at higher position.
Water tank has not been
installed in place.
Filter is missed to install
Un-known malfunctions
The appliance comes into
auto-shut off mode.
The set temperature has not
been reached.
Steam button is not set at
steam ironing position.
Re-plug the unit to main socket.
Set to the required position.
Switch the appliance ON
Lay handle down
Take it to qualified service man
or manufacturer for repair.
Fill water to water tank as
described in "Fill water tank".
Set temperature setting knob to
suitable position refer to Fabric
setting chart.
Allow sufficient time for iron to
preheat or set higher
temperature.
Set to lower steam setting.
Well install the water tank
Install the filter
Take it to qualified service man
or manufacturer for repair.
Press power ON/OFF to reset it.
Allow sufficient time to preheat
until heating indicator light turn
off.
Ensure the steam button is set
at steam ironing position and
steam indicator light is ON.
13
Solution