Displaying The Temperature Detected By The Separate Probe; Statistical Data - Fantini Cosmi CH150 Manual

Preset parameter reset
To resume the preset temperature profi les
and values (T1-T2-T3-Temperature
with the Manual mode, Temperature used
with the Jolly mode, Antifreeze temperature,
OFF function), keep the ▲ and ▼ buttons
depressed simultaneously when you are in the
temperature profi le programming mode.
Displaying the temperature detected by
the separate probe
To display the temperature detected by the
separate probe (only if the latter has been
confi gured as an external probe or fl oor-
mounted probe), the programmable thermostat
must be confi gured (refer to <<programmable
thermostat confi guration>>) and the probe
must be connected.
To display the temperature value read by
the separate probe, press the button of
the operating mode currently used (the
temperature will blink).
To display again the temperature detected by
the programmable thermostat, press again the
button of the operating mode currently used
(the temperature will not blink any longer).

Statistical data

The CH150 programmable thermostat pro-
used vides a set of statistical data concerning the
system operation. To access this data, pro-
ceed as follows:
1.Enter the programming menu main page.
The operating mode currently used will be
interrupted temporarily. Choose the statistical
data function.
2. Page 1: number of
hours during which the
system was operated
on the previous day (6
hours in the image).
Use the ► button to go
to the next page.
15