Rear Panel Rmw10; Handheld Transmitter Wmp - PROEL RMW10 Manual

RMW10

Rear Panel RMW10

1. antenna A input
Insert one of the two antennas included in the supply, screw the metal ring and position vertically.
2. antenna B input
See point 1
3. XLR Balanced Audio output
this output is recommended when presence of long distance between RMW10 and the mixer amplifier. Ensure then to use
balanced shielded cable and XLR Female connector.
4. 6.3 Jack Mono Unbalanced audio output
To grant a high signal level do not use such output for long distance between RMW10 and the mixer/amplifier .
Use a jack mono 6.3 and a shielded unbalance cable.
5. VDC Power Connector
Connect AC/DC power supply to VDC and ensure to connect previously to the main power supply 220-230Vac.

Handheld Transmitter WMP

1. Grille for microphone capsule protection
2. Display
Indicates the antenna symbol ( when TX and RX are coupled), operating frequency , battery charge level Channel and frequency
group, (PL) transmission power, LOCK.
3. CH/ON
Press for one second to switch on the Transmitter. Transmitter displays the current frequency, the battery charge level. Press
newly to pass in a cyclic mode to the following functions: CHANNEL - GROUP - PL - LOCK / UNLOCK. To disable the transmitter
press and keep pressing for one second.
4. SELECT
Functions mode operating allows value selection.
5. Battery location
Unscrew microphone body to insert two AA 1,5V batteries ( optional rechargeable) respecting the polarity.
6. Antenna
In case such antenna is covered (by hands for example), the signal can be attenuated with the possibility of signal loss or noise.
18