Cleaning and checking
1.
Clean and check carefully all components.
Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
2.
Check that the recoil spring is intact and
retains all its tension.
6.10 Assembling the throttle lockout,
throttle and spring
1
Do the procedure in chapter 6.9 Dismantling the
throttle lockout, throttle and spring in the reverse
order.
6.11 Assembling the belt eyelet
The chain saw is fitted with two eyes at the rear
edge of the chain saw housing, a rope eye and a
belt attachment eye. The belt attachment eye is not
fitted on delivery.
1
Remove the cylinder cover. See Figure 21.
2
Fit the belt attachment eye in its mounting as
outlined in Figure 22. Insert the screw through both
eyes and tighten. Tightening torque of 1.5 - 2 Nm.
Fig 20
Fig 21
Fig 22
Safety equipment
21
English –