Husqvarna T525 Workshop Manual page 47

Dismantling top damper
1. Remove the throttle components.
2. Remove the air filter.
3. Remove the carburetor.
4. Remove the engine case cover.
5. Press down the inlet pipe through the right
handle and pull up the right handle. Disconnect
all the hoses. See Figure 63.
6. Remove the safety wire (B). See Figure 64a.
7. Twist the upper spring holder (A) and antivi-
bration element (C) until it separates from the
lower spring holder (D). See Figure 64a.
Dismantling top damper (alternative)
The whole antivibration section (A, B, C and D ,
see Figure 64a) can be removed.
1. Remove the throttle components.
2. Remove the air filter.
3. Remove the carburetor.
4. Remove the engine case cover.
5. Press down the inlet pipe through the right
handle and pull up the right handle. Disconnect
all the hoses. See Figure 63.
6. Remove the clutch cover and the hand guard
assembly.
7. Remove the screw and lift the anitvibration ele-
ment assembly. See Figure 64b.
Cleaning and checking
Clean and inspect all parts.
Assembly
1. Assemble the parts in the reverse order. Make
sure to use the correct torque. See Service
Data.
Fig 63
A
C
Fig 64a
Fig 64b
Repair instructions
B
D
47
English –