Assembling The Centrifugal Clutch; Dismantling The Oil Pump And Screen - Husqvarna T525 Workshop Manual

Repair instructions

7.10 Assembling the centrifugal clutch

1
Hook the springs into the clutch shoes. Press in
the clutch hub from above while bending back the
clutch shoes around the clutch hub as shown in
Figure 26.
2
Screw in the clutch (anti-clockwise) until it stops.
Then tighten the clutch using a 13 mm socket
spanner. Tightening torque of 23.5 Nm. See Figure
23.
3
Remove the piston stop and fit the spark plug and
spark plug cap. Tightening torque for the spark
plug is 7.9 - 10.8 Nm.
4
Assemble the cylinder cover, saw bar, saw chain
and clutch cover.
7.11 Dismantling the oil pump and
screen
1
Empty and clean the oil tank.
Dismantle the centrifugal clutch. See the
"Dismantling the centrifugal clutch" chapter.
Dismantle the clutch drum and the needle bearing.
Note! The chamfering of the washer must be
turned towards the engine.
Make a note of how the chamfering of the
washer is put when you disassemble. Make
sure to put the chamfering of the washer
turned towards the enginewhen the product is
assembled.
See Figure 27.
2
Loosen the screw as outlined in Figure 28 and
remove the chain guide plate.
30
– English
Fig 26
Fig 27
Fig 28