Assembling The Ignition Module And Flywheel - Husqvarna T525 Workshop Manual

Repair instructions
7.8 Assembling the ignition module and
the flywheel
1
Fit the flywheel onto the crankshaft journal. Turn
the flywheel until the key fits into the key slot on the
axle. See figure 18.
The ignition module must be fitted as follows:
2
Pull the ignition module cabling through the
crankcase and place the ignition module in
position. See Figure 19.
3
Turn the flywheel so that the magnets are aligned
with the ignition module and place the plastic feeler
gauge, 514 24 41-01, between the lugs on the
ignition module and the flywheel magnets. See
Figure 20.
4
Tighten the screws for the ignition module and
remove the plastic feeler gauge.
5
Fit the spark plug cap on the ignition cable.
Note! When fitting a new ignition module a hole
has to be made in the ignition cable for the spring.
Use the assembly pliers, 502 50 06-01. See Figure
21.
6
Pull the ignition cable through the tank unit to the
spark plug.
7
Attach the:
• Starter unit
• Stop switch
• Spark plug
• Spark plug cable
• Cylinder cover
28
– English
Fig 18
Fig 19
Fig 20
Fig 21
0,4 mm.