Maintenance; Fabric Care - Lippert Components Edge Awning Owner's Manual

Maintenance

Resources Required
• 5 gallon bucket
• Clean water

Fabric Care

Over-spray of cleaning solution can cause eye and sensitive skin irritation. Flush affected area with clean
water and seek medical attention, if necessary. Wear eye protection and appropriate protective clothing
If the awning is retracted while wet, extend the awning and let it dry as soon as conditions allow before
retracting. This will help prevent the formation of mildew and add greatly to the life of the awning.
NOTE: Mildew does not form on the fabric itself, but on the accumulated dust, dirt and grime.
Periodically clean vinyl or woven acrylic fabric using a mixture of
warm water.
1.
Liberally apply the mixture on the top of the fabric and retract the awning for five minutes. This will
apply the mixture to the bottom of the fabric as well.
2.
Extend the awning and hose off with fresh water.
3.
Repeat if necessary.
4. Allow to dry before retracting.
Rev: 07.24.19
to avoid personal injury.
Moving parts can pinch, crush or cut. Keep clear and use caution.
1/4
• cup of dish soap
1/4
cup of dish soap and five gallons of
Page 7
CCD-0002686