Nespresso VERTUO User Manual page 30

9 Light blinks while machine is • If co ee is flowing normally, this indicates the machine is working
properly.
running.
• If only water is flowing, the machine is executing a user request for either
cleaning, descaling or emptying the system. Refer to the corresponding
paragraph in this user manual.
• Turn the machine to "OFF mode" by pushing the bu on for 3 seconds and
then push it again to turn the machine ON. Now wait approximately
20 minutes to allow the machine to cool down a er extensive use.
10 Light blinks and machine is not • It will take some time before the co ee flow comes out (due to barcode
reading and pre-we ing the co ee).
running.
• Check that a fresh capsule is inserted in correct position, that the handle is
properly locked and push the bu on to start.
• Fill the water tank and push bu on to start.
• Turn the machine to "OFF mode" by pushing the bu on for 3 seconds
and then push it again to turn the machine ON. Now wait approximately
20 minutes to allow the machine to cool down a er extensive use.
11 Light blinks alternately 2 blinks • During regular Co ee/Espresso preparation: 1) Unlock the handle and
open the machine head to check that a fresh undamaged capsule is
and 1 pause continuously.
inserted in the correct position.
Machine is not running.
2) Check that the handle is in "LOCKED" position. 3) Check that the water
tank is filled.
• During Descaling, Emptying and Cleaning: 1) Check that capsule is
ejected. 2) Check that the handle is in "LOCKED" position.
• During Programming Volume: 1) Check if a capsule has been well inserted.
2) Please refer to the corresponding chapter.
• If problem persists:
1. Unlock the handle and open machine head.
2. Replace capsule (if needed).
3. Disconnect powercord from the outlet and plug the machine back into
outlet a er 10 seconds.
4. Close the head and press the bu on to turn ON and press again to start
brewing. If problem persists, call Nespresso.
12 Light alternately blinking • Descaling needed: machine can be operated when alert appears only a
few times a er this alert before descaling becomes necessary.
3 times and then steady on.
VERTUO PLUS
7b Co ee leakage. • Open the machine head and let the capsule be ejected. Then perform a
cleaning.
• Empty and clean the cup support.
• Descale if necessary.
• If problem persists, call the Nespresso Club.
FR
VERTUO / VERTUO NEXT / VERTUO PLUS
1 Aucun voyant n'est allumé sur • La machine s'est éteinte automatiquement ; appuyez sur le bouton ou
déverrouillez la machine.
le bouton.
• Vérifiez l'alimentation secteur, la prise, la tension et le fusible.
2 Le café et l'eau ne s'écoulent • Vérifiez que le réservoir d'eau est rempli.
pas.
• Vérifiez qu'une capsule neuve est correctement insérée et que la poignée est
bien verrouillée. Appuyez sur le bouton pour démarrer la préparation du café.
• Procédez au détartrage de la machine si nécessaire.
• Ouvrez la partie supérieure de la machine ; la capsule est éjectée
automatiquement. Lancez ensuite la procédure de ne oyage conformément
aux instructions figurant à la section « Ne oyage » du présent guide.
34
UM_NEW LAYOUT_VERTUO_1.indd 34 UM_NEW LAYOUT_VERTUO_1.indd 34 31.03.20 09:21 31.03.20 09:21