Multi Restarts All The Time (After Every ~10Sec); What Is Error #42?; Gpl Note - Victron energy Color Control GX Faq

Last update: 2020-10-15 10:33
Typic the following address into the web browser of a device connected to the same network. Using
this address as a template:
square brackets). The IP address can be found by going to Settings > Ethernet or Wifi. Once the page
is loaded, Choose an image file from your device. Re-boot the
Q23: Multi restarts all the time (after every ~10sec)
Please check the remote switch connection on the Multi control PCB. There should be a wire bridge
between the left and middle terminal. The CCGX switches a line which enables the power of the Multi
control board. After 10 seconds this line is released and the Multi should take over from there. When
the remote switch connection is not wired the Multi is unable to take over it's own supply. The CCGX
will retry, the Multi will boot and after 10 seconds stop, and so on.
Q24: What is Error #42?
If the GX Device shows an Error 42 - Hardware fault. In that case, the flash storage on the device is
corrupt. As a result, settings will not be saved (rebooting resets back to default) and other problems
will rise.
This error is not recoverable in the field or by repair departments. Contact your dealer for a
replacement.
Firmware versions until v2.30 did not report the error. Since v2.30; its visible on the device itself (in
the GUI) and on the VRM Portal.

GPL Note

The software included in this product contains copyrighted software that is licensed under the GPL.
You may obtain the Corresponding Source code from us for a period of three years after our last
shipment of this product.
From:
https://www.victronenergy.com/live/
Permanent link:
https://www.victronenergy.com/live/ccgx:ccgx_faq
Last update: 2020-10-15 10:33
https://www.victronenergy.com/live/
ccgx:ccgx_faq
http://[ip-here]/logo.php
- Victron Energy
https://www.victronenergy.com/live/ccgx:ccgx_faq
(inserting your device's IP address between the
GX device.
Printed on 2020-10-15 20:48