Advertisement
Instructional Booklet
Page 38
Effective: August 2007
Figure 67. Braided TVSS Wires.
Step 7: The red and black wires from the TVSS are to be con-
nected to the terminals of the TVSS fuse block. Strip
0.25 in. (6.35 mm) of insulation from the end of the
wires.
Step 8: Connect the red and black TVSS wires to the TVSS fuse
block, as shown, using a blade screwdriver (see Figure
62).
Step 9: The white wire from the TVSS will be connected to the
neutral bar. Cut the white wire to a suitable length to
connect to the neutral bar then strip 0.25 in. (6.35 mm)
of insulation from the end of the wire.
Step 10: On 100 A SE ATSs, secure the white TVSS wire to a
receptacle on the neutral bar using a blade screwdriver
(see Figure 68).
Note: On 200 A SE ATSs, the white TVSS wire must be connected to the
male flag receptacle on the neutral bar. Remove the female flag connector
from the neutral bar. Cut the female flag connector off of the white wire
from the main wiring harness and the red wire from the optional load shed
if installed. Strip 0.25 in. (6.35 mm) of insulation from the white TVSS
wire, the white wire from the main wiring harness, and red wire from the
optional load shed if installed. Crimp the supplied female flag connector on
the wires so they can be connected to the male flag terminal on the neutral
bar (see Figure 68).
Figure 68. TVSS White Wire Connected to the 100 A and 200 A
Neutral Bars.
Step 11: The green / yellow wire from the TVS will be connected
Step 12: Secure the green / yellow TVSS wire to a receptacle on
Figure 69. TVSS Green / Yellow Wire Connected to the Ground
Bar.
For more information visit: www.eaton.com
O & M Manual for the CHGENLC Automatic
Transfer Switch with ATC-100 Control
100 A
200 A
to the ground bar. Cut the green / yellow wire to a suit-
able length to connect to the ground bar then strip 0.25
in. (6.35 mm) of insulation from the end of the wire.
the ground bar using a blade screwdriver.
IB00405002E
Advertisement
