NUCLEONIX SYSTEMS RC 705E Instruction Manual page 16

5.2.8 PASSWORD TO RECALIB
This is a very useful & important feature, it allows one to calibrate the unit to obtain expected dose rate for
the type of the scintillator used. This is to be changed only if user intends to recalibrate the unit.
5.2.9 BUZZER
On pressing PROG key the following display appears,
The default buzzer condition is OFF. User can change this by pressing increment or decrement
5.2.10 RECALL DATA READINGS
This is a very useful feature that has been provided in this unit. At the end of storing/saving of a set of
readings, this feature will enable the users to recall the readings on to the display, from the Sl.No. set in the
"RECALL" mode. Changing of the Sl.No. is similar to that explained under "SL. NO." selection.
By pressing PROG key, display changes to,
PASSWORD TO
RE‐CALIB?
To recalibrate press increment or decrement keys to get the following display.
PASSWORD TO
RE-CALIB?
Now on pressing PROG key, the existing calibration factor is displayed and user
can change it with increment or decrement
CAL.
XX.XX
FACT
BUZZER OFF
BUZZER ON
Time
RECALL XX.XX
XXX XXXXXX
Doserate
Sl.No
XX
90
keys to get new calibration factor
Date
Lable
Units
XX/XX XX
>
m/hr
>
keys.
Page 8 of 49