Hiniker 702 Operator's Manual page 23

NOTE: New hydraulic cylinders will leak a
small amount of oil until packings become
saturated and produce a good seal. If leakage
is excessive, or if leaking continues after initial
cycling, tighten the cylinder packing nut in 1/8-
turn increments until leaking stops.
21. Fasten the power unit cover onto the lift
frame bracket with two 1/4" x 3/4" screws,
fl at washers and lock nuts from the
hardware bag in the parts box. Tighten the
lock nuts so that the assembly is secure,
yet the cover hinges freely.
When the cover is closed, rods from the
latch handles should extend behind the
light brackets to hold the cover in place.
22. Assemble side markers on the ends of the
moldboard with 5/16 inch bolts, fl at washers
and lock nuts.
DWG NO. 6310
DWG NO. 7219
Plow Assembly 21