Table of Contents
Advertisement
14
Plow Assembly
Install the 3/4 inch x 4 1/4 inch hex bolt
removed earlier so the bolt head is retained
by the lock plate on the push frame. Secure
the assembly with the 3/4 inch slotted nut
and cotter pin so the plow blade is free to
pivot.
Use clevis pins and cotter pins to fasten
the hydraulic cylinder rods between lugs
on the moldboard. Cylinder ports should be
directed up.
2.
From the parts box, remove two extension
springs.
Inside the hardware bag, fi nd two threaded
spring studs and two 5/8 inch nylon insert
lock nuts.
Slide a spring stud onto each spring, then
assemble springs between lugs on the
moldboard pivot tube and channels along
the upper edge of the blade.
Tighten lock nuts until spring coils begin to
separate.
3.
DWG NO. 5698B
4.
DWG NO. 5692A
Gently tip the plow assembly to its working
position with a hoist or forklift. Pin the parking
stand to hold the push frame parallel to the
ground.
Swing the lift frame up to its approximate
working position and hold with a hoist or
forklift for installation of the lift cylinder.
The bottom surface inside the two prong
receiver channels should measure about
10 inches above the ground in the working
position.
O
Locate the 90
O-ring/fl are adapter in the
hardware bag from the parts box.
Install the O-ring end of the 90
lift cylinder port so that the fl ared end points
toward the rod end when tightened.
Pin the lower end of the lift cylinder between
the lugs on the frame assembly with the
hardware provided. The 90
be on the RH side of the cylinder.
DWG NO. 5696
DWG NO. 5699
O
fi tting into the
O
adapter should
Advertisement
Table of Contents
