Hiniker 702 Operator's Manual page 20

18 Plow Assembly
Truck Battery On Driver Side
Refer to drawing 6700. Remove the tape
from the black corrugated loom at the
points shown. Locate an Orange, Red, and
two Black wires. These wires connect to the
battery and motor solenoid. Remove the
four wires from approximately 33 inches of
the loom, making sure the Red and Black
wires are long enough to connect to the
battery. Tuck these wires back into the
loom as shown in the drawing and retape
the loom.
10. If there is no access hole in the drivers side
fi rewall then drill a 1-1/8 inch diameter hole.
Route the 7-pin circular connector through
the fi rewall into the cab compartment and
install the 4 inch grommet in the hole, if
required.
CAUTION: Ensure that the relays will
clear any hood lift/spring mechanisms
before installation.
11. Select an area near the driver's side in ner
fender to mount the four relay set. Drill two
1/8" diameter holes and secure the relays
using #8 x 1 1/2" self-tapping screws from
the hardware bag in the parts box. Apply a
light coat of dielectric grease on the relays
before inserting into holders.
NOTE: Always mount the relays with the wires
pointing down to prevent contamination.
Repeat this procedure and mount the three
relay set on the passenger side inner fender.
12. Splice the red with white stripe wire to the
vehicle's switched 12 volt auxiliary electrical
circuit. This will prevent operation of the
plow without the vehicle key being on.
This wire controls the accessory relay that
powers the control joystick and solenoids.
DWG NO. 6700