Hiniker 702 Operator's Manual page 19

Connect the RH headlamp to the wiring
harness end labeled "PSNGR SIDE" and the
LH headlamp to the end labeled "DRIVER
SIDE".
Ensure connections are fully mated for proper
sealing. There should be no gaps between
connector halves. Secure these cables to the
frame with plastic ties.
NOTE: Install the plow harness so that water
does not run down the wires and pool inside the
"Y" connection. Position the harness so that any
trapped water can easily drain away.
WARNING: Disconnect truck battery
before beginning electrical installation
to avoid shock hazard.
8. The motor solenoid,
harness, power cable and joystick control box
are located in the parts box shipped with the
snowplow frame.
Truck Battery On Passenger Side
underhood wiring
NOTE: To prevent corrosion lightly coat all
electrical connections, ring and spade terminals
with dielectric grease prior to assembly.
Refer to drawing 6699. Lay the underhood
harness in it's approximate position for fi nal
assembly with the 7-pin circular connec-
tor near the driver's side fi rewall. Place the
16-pin connector just left of center near the
grill, the set of four relays near the driver's
side inner fender and the other set near
the passenger side inner fender. Place the
5-pin headlight connectors at the respective
head lights.
9. Determine the location of the vehicle
battery. If the battery is located on the
right (passenger) side or if there are two
batteries confi gured as a 12 volt system
then proceed to step 10. If the battery is
located on the left side of the vehicle then
the wiring harness will need to be modifi ed.
Plow Assembly 17
DWG NO. 6699