Hiniker 702 Operator's Manual page 22

20 Plow Assembly
17. Locate three blue connector splices in the
hardware bag in the plow's parts box.
Using a blue splice, crimp the single brown
wire from the underhood harness into the
vehicle's driver's side parking light wire.
Using a blue splice, crimp the single yellow
wire from the underhood harness into the
vehicle's driver's side turn signal wire.
Using a blue splice, crimp the single green
wire from the underhood harness into the
vehicle's curbside turn signal wire.
18. Select the proper headlight adapter for your
vehicle, specifi c instructions are included
with each kit.
The headlight adapter kit consists of two
identical adapters. Install the adapters
according to the instructions included with
the kit and connect to the 5-pin connectors
of the underhood wiring harness.
19. Secure all cables away from hot or moving
components with cable ties.
This completes the Electrical Installation.
20. At this point, the mount kit should be
assembled onto the truck.
Prongs from the truck mount kit should be at
a height that will slightly lift the plow frame
when attaching the plow. Prong receivers
on the plow frame should be parallel to
the ground when attaching the plow. Apply
powered graphite on the truck prongs to
help the plow to slide on and off more easily.
Handle Pinned With Plow on Truck
DWG NO. 4165
Attach the plow onto the truck by driving the
truck prongs into the receivers on the plow
frame. Pull the latch handle into the frame
clevis to move sliders through the notches
in the prongs and receivers. Pin the handle
in the clevis with its klik pin.
Raise the parking stand to its highest
position and repin.
Connect the two electrical cables from the
plow to their corresponding receptacles on
the truck.
Select Hiniker Cold Flow Hydraulic Oil,
or an equivalent oil that meets military
specifi cation 5606, for plowing in extremely
cold temperatures.
Pour hydraulic oil into the power unit oil
reservoir until the reservoir is half full.
Angle the plow full left or right with the
cab control box inside the truck to fill the
angling cylinder with oil. Add more oil
until the reservoir is about 3/4 full. Do not
over-fill the reservoir.
Cycle the plow left and right and up and
down to purge any air trapped in the
hydraulic system.
Check the oil level with the plow on the
ground. Add oil to the fill line, if necessary,
but do not overfill the reservoir.
DWG NO. 5691