Table of Contents
Advertisement
Installation procedures
The update starts. This action can take a long time. A message is displayed.
9.
Click Yes to continue (4).
The update file will be transferred to the projector and installed. The projector will reboot.
A message is displayed. Click Ok to clear the message.
How to update the software if the projector isn't connected to the network
1.
Power on the projector. Wait until the Power on/off button is either lit white or blue.
2.
Download the latest firmware file ( format .fw) from Barco's website. The firmware can be downloaded for
free from Barco's website, (URL: http://www.barco.com). Click on myBarco and log in to get access to
secured information. Registration is necessary.
If you are not yet registered, click on New to myBarco and follow the instructions. With the created login
and password, it is possible to log in where you can download the software.
3.
Place the firmware file on a clean USB flash drive.
Note: Make sure the flash drive is FAT32 compatible & no other files are on the flash drive.
4.
Plug the flash drive in the USB port on the Communication Panel.
The update file will be transferred to the projector and installed. The projector will reboot when completed.
CAUTION: While it is technically possible to "downgrade" the software to an older version using this
method, it is NOT recommended and should be avoided as much as possible. Certain features will
no longer be supported, projectors can display unwanted behavior during the downgrade and in
some rare cases, this may even bring damage to the device. Always contact Barco if you want to
make sure a downgrade will not hurt your device.
Take note that the update process can take a long time to complete.
For more info about the Projector Toolset see user guide of the Projector Toolset.
58
R5913593 /01
Njord
Advertisement
Table of Contents
