Table of Contents
Advertisement
Prepare to install
3.2 Unpacking the projector
Unpacking process and handling
The projector can be delivered in a cardboard box on a pallet or within a rigging frame inside a flight case. This
chapter describes how to unpack the projector from the cardboard box. For how to handle the projector with
rigging frame and flight case see "Flight case and rigging frame", page 183.
The box and pallet is secured with a banding and locking clips. To further protect the projector during
transportation handling, it is surrounded with a sheet of polymeric foam. When the projector arrives the
installation site, it needs to be removed from the box and pallet in a safe manner, without damaging the
projector.
After unpacking let the projector acclimatize to a room temperature between 10°C (50°F) and 40°C
(104°F). Neglecting this may result in a start up failure of the Light Processor Unit.
Required tools
Cutter knife
How to unpack
1.
Use a cutter knife, or release as shown in the figure below to remove the banding around the cardboard
box and pallet.
Use the same knife to cut the adhesive tape that closes the box.
Image 3–3
2.
Remove the foam inlays. These inlays also contain the accessories for the projector.
3.
Remove the polymeric foam sheet.
4.
Lift the projector out of the box.
28
R5913593 /01
Njord
Advertisement
Table of Contents
