Type J Measurement; Pt 100 Ohm Measurement - Lutron Electronics TM-946 Manual

4)Insert the Type K probes into the " T1, T2, T3, T4 input
socket " ( 3-9, Fig. 1 ).
The LCD will show the 4 channels ( T1, T2, T3, T4 )
temperature value at the same time.
* If the certain channels do not insert the temperature
probes, the relative channel display will show over
range " - - - - - ".

4-2 Type J measurement

All the measuring procedures are same as the Type K
( section 4-1 ) except to select the function to " Type J "
by pressing the " Function button " ( 3-5, Fig. 1 ) once
until the up LCD display show " J " indicator.

4-3 Pt 100 ohm measurement

All the measuring procedures are same as the Type K
( section 4-1 ) except :
1)Pressing the " Function button " ( 3-5, Fig. 1 )
until the right down LCD display show " Pt "
2)Insert the Pt 100 ohm probe to
PT1 input socket ( 3-10, Fig. 1 )
PT2 input socket ( 3-11, Fig. 1 )
Pt
7