Autopilot ChlorSync CS30 Owners & Installation Manual page 16

Chlorine
The desirable form of chlorine is called Free Chlorine. This form of chlorine is responsible for the
actual sanitation activity in pools and spas. Free chlorine is highly reactive and, once added to
pool/spa water, has a tendency to combine with organic matter in the pool/spa. It quickly attacks
pathogens as well as other bather wastes. When chlorine combines, it chemically changes. The
chlorine binds to organic matter and is referred to as Combined Chlorine. Combined chlorine is
responsible for eye burn and skin irritations. Total Chlorine is the sum of free chlorine and
combined chlorine. If a strong chlorine odor is noted, it is due to an excess of combined chlorine.
It is important to test the total chlorine as well as free chlorine. If there is a difference greater than
0.2 ppm (mg/L), a shock treatment should be initiated.
During peak chlorine demand (summer months, rainy season or heavy bather usage) it may be
necessary to increase your chlorine output by increasing your sanitizer output setting.
Conversely, during low chlorine demand, you can decrease your output to a lower setting. For
extremely heavy chlorine demand or to boost your chlorine residual levels quickly, you can
supplement with any type of chlorine or non-chlorine shock containing potassium
monopersulfate. Avoid using excess amounts of treatments containing sodium bromide.
Note: During cold-water conditions (below 60ºF (15.6ºC)) chlorine demand is reduced
significantly. For colder climate regions with sustained low temperatures, contact your local pool
professional for proper pool winterizing instructions.
pH
pH is a term used to refer to the degree of activity of an acid or base in the water. A low pH,
acidic or corrosive water, contributes to eye and skin irritation as well as damage to pool
equipment. A high pH will result in scaling, cloudy water and ineffective sanitation. Improper pH
also contributes to the strong smell, red eyes and dry itchy skin conditions that are usually
blamed on "too much chlorine" being in the pool/spa.
Total Alkalinity
Total Alkalinity refers to the ability of the pool water to resist a change in pH. It helps manage or
control the pH in the pool. The desired range is 80 to 100 ppm (mg/L). Low alkalinity is
aggressive or corrosive and causes the pH readings to fluctuate (pH bounce). High alkalinity
may cause cloudy water and scale forming conditions. Your chlorinator does not affect total
alkalinity. Factors changing this measure are ancillary chemicals added to the pool and "out of
balance" make-up water.
Calcium Hardness
Calcium Hardness is a measure of calcium content in the water. If the calcium content is too
high, calcium can drop out of solution; forming scale on equipment. A low level will cause the
water to become corrosive as the water tries to naturally form equilibrium. This means the water
will "leach" minerals from everything it meets. Damage to equipment and unpleasant swimming
conditions result. Your chlorinator does not change calcium hardness. Factors changing this
measure are ancillary chemicals added to the pool and "out of balance" make-up water.
Page - 12