Rear Shock Absorber Adjustment; General Lubrication; Vehicle Data Recorder - Sym MAXSYM 400 Manual

NOTE :
 Obey local regulations for headlight aiming adjustment.

Rear Shock Absorber Adjustment

This scooter is equipped with two 5-position spring preload adjustable rear shock absorbers. The standard
position is 3. To adjust the preload setting, follow the below steps.
 Set the scooter upright with the main stand.
 To set the spring harder, turn the adjuster ○
preload, align the expected position with the position indicator ○
 To set the spring softer, turn the adjuster anti-clockwise ○
decrease preload, align the expected position with the position indicator.
NOTE :
 Do not exceed the adjuster's limit.
 Even though the spring preload can be adjusted by hands, using the C-spanner can prevent you from
injury.
 Please set the springs harder before the passenger get on the scooter.

General Lubrication

Lubricate the below parts with either engine oil or general grease in accordance with the "Periodic
Maintenance Schedule" (page 53) or whenever the vehicle has been operated under wet or rainy conditions.
Clean off rusty spots and wipe off any oil or grease.
 Side stand pivot.
 Main stand pivot.
 Front / rear brake lever pivots.
 Throttle cables.
 Parking brake cable.

Vehicle Data Recorder

This scooter is equipped with an ECU that can record or collect vehicle data for trouble diagnosis and
research. The data must be received by a special diagnostic tool when carrying out maintenance or check-
up. SYM will not transfer the data to any third party except:
 The owner or user agrees.
 Stipulated by laws.
 In need of lawsuit.
 For research and development, and the data is irrelevant to an individual unit or the owner.
clockwise ○
A
○
a
○
b
○
A
47
with the C-spanner in the toll kit to increase
a
.
B
with the C-spanner in the tool kit to
b
○
B