Front/Rear Brake Lever - Sym MAXSYM 400 Manual

○ Hazard Switch
B
Push the switch to
turn signal indicators will blink.
NOTE :
 Do not use the hazard lights for a long period of time, or the battery may become totally discharged.
○ Dimmer Switch
C
High and low beam can be selected with this switch. When the headlight is on high beam
beam indicator (page 10) goes on.
High beam
Low beam
○ Turn Signal Switch
D
When the turn signal switch is turned to the left
and off. To stop blinking, push the switch in.
Horn Button
○
E
When the horn button is pushed when the ignition switch is turned on; the horn sounds.
TCS Button
○
F
This scooter is equipped with traction control system (TCS). The traction control system can be turned
off/on by pushing this button for approximately 3 seconds. Refer to page 32 for more information.

Front/Rear Brake Lever

This scooter is equipped with four-position adjustable front/rear brake levers for fitting different hand sizes.
To adjust the brake levers, do the below steps:
 Push the brake lever forward ○
 Turn the adjuster ○
lever forward.
 Release the brake lever and check that the lever operates correctly.
position when the ignition switch is in "On" position. All the turn signal lights and
○
a
.
a
until the number (position) aligns with the indicative mark ○
A
or right , the corresponding turn signals blink on
○
A
○
B
22
, the high
while pushing the
B