Shock Build - Associated Electrics ELEMENT RC ENDURO GATEKEEPER KIT 40110 Owners Build Manual

14
GATE 02
SHOCK BUILD: BAG 9
Shock Bleeding Steps:
1. Pull shock shaft down.
2. Fill shock body 3/4 full with silicone fluid.
3. Slowly move the shock shaft up and down to remove air from
under piston.
4. Wait for bubbles to come to surface.
5. Fill shock body to top with silicone fluid.
6. Place a drop of oil in the cap and on cap threads.
7. Install cap and tighten completely.
8. Slowly compress shaft all the way to the top. If there is
pressure at the top of the stroke, there is too much oil or air.
You must bleed it out.
9. Slowly pull shaft out.
10. Unscrew the cap 3/4 turn and tilt the shock at a slight angle.
11. Slowly compress the shaft to push out excess oil and air.
You should see bubbles coming out from under the cap.
12. With the shaft compressed, tighten the cap and re-check for
pressure at the top of the stroke. If there is still pressure,
repeat steps 9 thru11.
GATE 03
SHOCK BUILD: BAG 9
SHOCK CAP
O-RING
SHOCK COLLAR
O-RING
x1 42081
O-Ring,
Shock Collar
x1 42079
Shock Collar,
Black, Aluminum
GATE 04
SHOCK BUILD: BAG 9
42256 x1
Nut
42263
x1
Nut
Step 1-3
42089
x1
Front Shock Spring,
Gray, 1.49 lb/in, 63mm
x1 42090
Rear Shock Spring,
Blue, 2.09 lb/in, 63mm
x1
42054 x1
FT Pivot Ball,
Steel, 6mm
Step 3-4 Step 5-6
x1 42260
42256
Shim,
Nut
3mm
x1 42055
Pivot Ball,
Upper Shock
41091
x1
3x20mm
LP SHCS
25187
3x14mm
BHCS
x1 42080
Shock Cap, Enduro,
Plastic
Step 7
3mm
42080
x1
Shock Spring Cup,
Plastic
NOTE: Build 4
complete shocks
x1
42054
x1
FT Pivot Ball,
Steel, 6mm
NOTE: Build 4
complete shocks
Step 8-12
x1 42263
Nut
x1 42260
Shim,
3mm
x1 42055
Pivot Ball,
Upper Shock
x1 41091
3x20mm
LP SHCS
x1 25187
3x14mm
BHCS