Matco Tools MM200 LCD Operator's Manual page 13

Welding parameters
available by rotating L
Knob
Two/four Stroke
Burn Back
Slow Feed
Pre-flow
Post Flow
Inductance
4. Selection of system setting parameters:
1) In the main interface, rotate the R knob to parameter setting interface;
2) Rotate L knob to select system settings:
5. Setting of welding current and voltage
1) Press the ENTER key to enter the welding interface shown below:
MAINTENANCE AND TROUBLESHOOTING
Welding parameters
available by rotating R
Knob
2T/4T
0-10
0-10
0-2 S
0-10 S
0-10
Fig. 2
- Ⅳ -