Toshiba BC Series Instruction Manual page 39

■ UserDefinedName
The camera's built-in user non-volatile memory can store up to 16 characters of user's arbitrary character
string.
GenCP
Register Read
address Write
0x0000 0184
| R/W
0x0000 0193
It can write and read directly to the user nonvolatile memory.
After writing to this register, the camera saves the written data to non-volatile memory immediately.
* In the case of GenCP, access must be performed in units of 4 bytes.
* The area of 0x0000 0194 to 0x0000 01C3 is not saved.
Legacy protocol
Register Read Memory
address Write save
0xD8 R/W
-
Specify the access start address of the user nonvolatile memory.
If the user area / byte count register is other than 1, this register must be a multiple of four.
Register Read Memory
address Write save
0xDA R/W -
Data is written to or read from the user nonvolatile memory specified by the user-specified address register.
Register Read Memory
address Write save
0xDB W.O. -
Erase all user non-volatile memory.
Register Read Memory
address Write save
0xDC R/W -
Specify the number of bytes to write / read in batch in the user area / data register.
Copyright © 2019 Toshiba Teli Corporation, All Rights Reserved.
Memory
Default Register name
save
Null
User Define Name
✓
string
Default Register name
0x0 User area : address
Default Register name
- User area : data
Default Register name
User area :
0x0
address
Default Register name
User area : byte
0x10
number
User-programmable device identifier.
Sets address of user area.
0x0～0xF(15)
Read /Write data to the specified by [User area : address].
The data length is specified by [User area : byte number].
Sets address of user area.
0x0～0xF(15)
Sets the byte number of R/W length of user area.
0x1, 0x4, 0x8, 0x10(16)
37 / 73
Description
Description
Description
Description
Description
D4296087A
http://www.toshiba-teli.co.jp/en/