Acquisitioncontrol - Toshiba BC Series Instruction Manual

AcquisitionControl

AcquisitionControl features are related to image acquisition.
If you need to stop the image output when changing the settings of various registers, you need to issue the
abort image output or stop image output command.
There are some registers that require camera to stop image output to change values.
Acquisition frame rate is variable. Maximum acquisition frame rate depends on camera operation mode.
(scalable, binning, decimation, CameraLink Tap, CameraLink CLK, etc.)
BC040M has HighFramerateMode. You can improve the frame rate by using HighFramerateMode.
● Register
IIDC2 address
Register Read Memory
address Write save
0x0020 303C R/W
0x0020 30A8 R/W
✓
0x0020 30BC R/W
✓
0x0020 30C8 R/W
✓
0x0020 30DC R/W
✓
0x0021 F59C R/W
✓
* 0.4M : BC040M, 1.6M : BC160M
Legacy アドレス
Register Read Memory
address Write save
0x80 R.O. -
* 0.4M : BC040M, 1.6M : BC160M
Copyright © 2019 Toshiba Teli Corporation, All Rights Reserved.
Default
Acquisition
- 0x8
Command
Acquisition
0x0
FrameRateControl
0.4M:0x736F31 Acquisition
1.6M:0x1E517F FrameRate
Aqcuisition
0x0
FrameIntervalControl
0.4M:0x4F4FB Acquisition
1.6M:0x12DF8A FrameInterval
0x0 HighFramerateMode
Default Register name
0.4M:0x71
Frame rate
1.6M:0x1D
Register name
0x0: Abort image output. 0x1: Stop image output.
0x8: Start image output.
0x0:NoSpecify Take priority ExposureTime setting.
0x1:Manual
Framerate
*AcquisitionFrameRate / 65536[fps]
0x0:NoSpecify Take priority ExposureTime setting.
0x1:Manual
Interval
*AcquisitionFrameInterval / 37500000[sec]
Only BC040M model.
0x0:OFF,0x1:ON
All pixels readout:
Calcurated from [CameralinkCLK / Cameralink Tap].
Scalable:
Calcurated from number of ouput lines.
53 / 73
Description
Take priority AcquisitionFrameRate setting.
Take priority AcquisitionFrameRate setting.
Description
D4296087A
http://www.toshiba-teli.co.jp/en/