Electrical Requirements; System Checklist - Q'STRAINT INQLINE Installation Manual

Power Supply
• All equipment and components must be installed and serviced by an experienced and trained technician.
• Connection to be 12Vdc using a 30 amp fuse between + terminal of battery and controller.
The following parts make up a complete INQLINE SECUREMENT™ Wheelchair Securement System. If any
questions arise, call your nearest Q'STRAINT ® authorized dealer or office.
2 INQLINE SECUREMENT™ Retractors (Washers and
q
Bolts not Included) ONLY use minimum grade 8.8,
M8 - 1.25x16 Bolts, Bolt length = all material thickness +
0.34" (8.64mm). Quantity: 6
1 Thumb Controller with Cord and Wall Mount
q
(screws not included)
1 Wall Control Panel (screws not included)
q
1 Main Control Box (screws and washers not included)
q
2 (10 ft.) Wire Harnesses
q
1 (10 ft.) Wall Unit Wire Harness
q
1 Split Wire Harness
q
2 Hook Hangers
q

ELECTRICAL REQUIREMENTS

SYSTEM CHECKLIST

SOLD SEPARATELY
INQLINE SECUREMENT™ Wheelchair Securement System
QRT Retractors (Compliant with RESNA WC-4, Section 18
q
and ISO-10542-1)
2 OMNI® Slide 'n Click
q
1 Occupant Securement System
q
(will vary depending on vehicle's model) (Sold Separately)
1 INQLINE SECUREMENT™ Installation Manual
q
1 INQLINE SECUREMENT™ User Placard
q
1 INQLINE SECUREMENT™ Use and Care Manual
q
1 Warranty Card
q
Wall Pouch
Q'STRAINT® Wall Pouch and Hardware
q
(Optional – Sold Separately)
7
Floor Anchorages
®