ABB ControlMaster CM10 Commissioning Instructions page 21

C O N T R O L M A S T E R C M 1 0 | U N I V E R S A L P R O C E S S C O N T R O L L E R , 1/8 D I N | C I/C M 1 0 - E N R E V. C
Icon Number/ Possible cause
Message
Temporary or permanent failure of analog to
242.004
digital converter on the main I/O board.
ADC 1 Failed
Problem with input assigned to Loop 1 PV.
250.000
Broken sensor leads, defective input source
PV 1 Failed
or input signal out of permitted range.
Problem with Input assigned to Loop 1
246.002
Remote Setpoint. Broken sensor leads,
RSP 1 Failed
defective input source or input signal out of
permitted range.
Error in Cold junction measurement
222.014
associated with AIN1. Wiring fault or
CJ 1 Failed
defective sensor.
Problem with input assigned to Loop 1 wild
230.010
variable. Broken sensor leads, defective
WV 1 Failed
input source or input signal out of permitted
range.
Problem with input assigned to Loop 1
234.008
position feedback. Broken sensor leads,
PFB 1 Failed
defective input source or input signal out of
permitted range.
Failure of non-volatile memory on processor/
216.016
display board or permanent corruption of its
NV Error
data.
Proc Bd
Suggested action
Cycle power to controller.
If problem persists replace main I/O board.
Contact local service organization.
Check wiring.
Check input source.
Check if input signal is outside permitted limits.
Check wiring.
Check input source.
Check if input signal is outside permitted limits.
Check cold junction device is correctly fitted.
Ensure I/P 2 is turned off.
Replace CJ sensor.
Check wiring.
Check input source.
Check if input signal is outside permitted limits.
Check wiring.
Check input source.
Check if input signal is outside permitted limits.
Check all configuration parameters and correct any errors.
Acknowledge error.
If problem persists contact local service organization.
21