Functions - Junghans Anytime Collection Manual

Following successful automatic synchronisation, the transmitter from which
the signal was picked up is permanently displayed. Thus if no signal was picked
up, no transmitter is displayed.
The date is always advanced automatically by the time signal. This process
also takes the 29th of February into account in leap years.
If all of the attempts at picking up a signal lead to no clear synchronisation, the
reception display is switched off (see also description of the 'Reception Display'
in section 6.3). On any such days without synchronisation, your watch conti-
nues to run with the accuracy of a quartz timepiece, using the internal time
memory. As soon as the signal is picked up again successfully, your watch is
synchronised and the reception display is switched back on.
Recommendation: To ensure the best possible conditions for overnight recep-
tion of the synchronisation signal, the watch should not be worn and, if possi-
ble, not left near to any electrical appliances, mobile or cordless phones.
Important note:
When travelling into a different reception area (e.g. going from Germany to
Japan) no automatic time or thus transmitter synchronisation occurs until the
watch's next attempt to pick up a signal. If the watch fails to pick up any
transmitter signal, please perform a manual transmitter call (see section 6.4
on manual synchronisation).
32

4. Functions

Using the winder
On the winder of your Junghans multi-frequency radio-controlled watch there
st
is a red mark (1 ratchet position). If this mark is visible at the 3 o'clock
position, all of the buttons' functions are disabled. If the mark is not visible
(2nd ratchet position), all of the functions are available.
Analogue display: Hours, minutes, seconds
LCD display: Day, date, transmitter display, 2
uage for day of week, power control display (if power is too low the second
hand positions itself in the 12 o'clock position and the LCD display flashes, alter-
nating between the then current display and 'Lo'. The seconds may also be
shown on the LCD display).
nd
time, stopwatch function, lang-
33