General Information - Junghans Anytime Collection Manual

What is shown on the LCD display switches to the month setting, e.g. [M 01].
You again perform the setting via the T2 button. The month you want must
then again be confirmed by briefly pressing the T1 button.
Perform the following settings using the procedure described above:
x Set the date - what is shown on the LCD display switches to [D 01]
x Set the hour - what is shown on the LCD display switches to [00: ]
x Set the minute - what is shown on the LCD display switches to [ :00]
In order to get the seconds displayed correctly, please ensure that you always
set the watch to the next full minute and confirm the time at the 60th second.
After you have set the minute and confirmed this by pressing button T1, the
hands of your radio-controlled watch then move to the time that you set. The
date is shown on the LCD display. A 2
If necessary, the programmed time can be corrected by holding down button
T2 for longer than 3 seconds.
Your watch is now in quartz mode and will not make any automatic attempts
to pick up a time signal. You can make a manual transmitter call, however, at
any time.
If you make a transmitter call while in quartz mode, then in addition to the
current seconds an [M] is displayed on the left. This indicates that the trans-
mitter call is being launched in quartz mode.
A successful transmitter call overwrites the manually set time and afterwards
your watch works as a radio-controlled watch.
42
nd
time can be set as normal.

8. General information

x Servicing, such as repairs to the glass, seal or wrist strap should only be
carried out by an authorised specialist.
x Please have the seals and the glass inspected regularly by an expert, approx.
every 2 years.
x If condensation gets into your watch, have it inspected by the Customer
Service Unit without delay. Water inside the watch can damage it.
x Your watch is fitted with a quality wrist strap that has undergone multiple
inspections in our factory. If, however, you decide to change the wrist strap,
please fit a new one of the same quality, preferably an original wrist strap.
x Clean your watch and wrist strap with a dry or slightly moist cloth. Caution:
do not use chemical cleaners (e.g. benzene or paint thinners). These may
harm the surface.
43