Operating Bianco Puro - bianco puro Instruction Manual

Operating BIANCO puro

into the power socket.
Start-up
In order to use your BIANCO puro, it is necessary to put on the mixing container on the motor block properly. Without mixing
container your BIANCO puro does not start. If you put the container on the engine block, you will hear a long beep and both
Energy Saving Mode
1
To switch on the device, place the mixing container (Fig.[1], page 2) on the locking mechanism (Fig.[10], page 2), this switches
the display on for 1 second and then automatically changes into the energy saving mode . In this mode the display is switched
1
off, only the On/Off button (Fig. [14] page 2) is lit red.
Standby Mode
You only have to press a button on the control panel or turn the Jog-dial to switch the device from energy saving mode to
standby mode. Make sure that the mixing container is put on properly. In this mode the display shows „00:00" minutes and the
speed is set to "3" and all symbols on the control panel are lit and
1
Power consumption in Energy Saving Mode: 0,339 Watt
EN
13