Operating Programme Buttons - bianco puro Instruction Manual

Operating Programme Buttons

On/Off Button
lit green. By pressing the On/Off button again the program is ended prematurely.
Pulse Button / Pulse Mode
With this button your BIANCO puro starts with the maximum speed level. During operation in Pulse mode you must keep this
button pressed. Your BIANCO puro stops automatically when the button is released. In Pulse mode „88:88" and „H" are shown
on the display.
Start of an Automatic Program
To start a program your BIANCO puro must be in standby mode. Now choose a program with the jog-dial, your choice of
the program on the display (Fig. [13], page 2). After the end of the program your BIANCO puro stops automatically.
Remove the mixing container only when the blades do not rotate anymore!
SPEED + / - und TIME + / -
Use these buttons to change the speed and time settings.
With the „+" button increase the speed or time. With the „-" button decrease it.
Speed Adjustment
The speed can be set from level 1 to level 10 (H). The display shows the levels as follows: „1, 2, 3, 4, 5, 6, 7, 8, 9, H".
Set the speed by pressing the button (SPEED +) and (SPEED –). In manual mode the speed can also be set during operation.
EN
12