Ppm (Wired) Zeroing/Drift Correction - PLC Electronic Solutions Veracity Control Wheels Operation Manual

PPM (Wired) Zeroing/Drift Correction

You may notice that the Monitor function on your RC controller shows the Veracity Control Wheels signal does not
return to zero. This offset can cause your camera mount to 'drift' as it is sending a signal for motion when it should not
be. If you are experiencing this, the following steps will correct it.
1) Switch all axis direction switches to the center position and set the Sensitivity Dials into the center of their
range.
2) Press and hold the Zero Button located on the back of the PAN Wheel, until you notice the direction LEDs on
each axis start flashing Red and Green. The system is now in Zeroing Mode and the Control Wheels are not
active.
3) Watch the monitor screen on your RC controller and use the Sensitivity Dial on each wheel to adjust the signal
until it reads zero on the RC monitor.
4) When all of the channels assigned to the Veracity Control Wheels are reading zero on the RC controller monitor,
press and hold the Zero Button until the LEDs stop flashing and are on solid, then release. The LEDs will go off.
The new offsets will be stored in the Veracity Control Wheels flash memory.
***Note: If zeroing is done without the TILT or ROLL Wheel plugged in, the missing channel will need to be re-
zeroed when it is attached. Zeroing will need to be performed with each RC controller that is used, as the offsets
required will vary.
***Note: If the Sensitivity Dial reaches the endpoint of its rotational range with its axis still drifting:
1. Press and hold the Zero Button to exit from Zeroing Mode.
2. Re-center the Sensitivity Dial.
3. Press and hold the Zero Button to get back into Zeroing Mode and continue to adjust for drift.
PLC Electronic Solutions Ltd.
www.plcelectronicsolutions.com
Copyright © 2017
Page 9