R&S RT-ZC20 User Manual page 18

www.allice.de
®
R&S RT-ZC20
4. Press the opening lever until the UNLOCK indication disappears. Make sure
that the sensor head is properly closed.
If the sensor head is not properly closed, accurate measurement is not possi-
ble.
The current consumption of clamp-on probes depends on the current to be
measured. Confirm that the total current consumption of the probes does
not exceed the rated output current of the R&S RT-ZA13 probe power sup-
ply.
Figure 3-3: Current consumption* vs. current to be measured (typical)
*The sum total of positive and negative current consumption.
User Manual 1409.7814.02 ─ 03
Allice Messtechnik GmbH
Putting into Operation
Connecting the Probe to the DUT
18