Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MSA MV-1901F
Summary of Contents for MSA MV-1901F
- Page 1 Limited Liability Company «NPK MORSVYAZAVTOMATICA» LCD DISPLAY MV-1901F Operating Manual info@unicont.com 26E, Kibalchicha str., 192174, Phone.: +7 (812) 622-23-10 www.unicont.com St Petersburg, Russia Fax: +7 (812) 362-76-36...
-
Page 2: Table Of Contents
Operating Manual TABLE OF CONTENT INTRODUCTION ......................... 3 DESCRIPTION AND OPERATION OF THE PRODUCT ..........4 1.1 Description ..........................4 1.2 Technical specifications ......................4 1.3 The Product’s structure and operation ..................4 1.4 Measurement tools, instruments and appliances ..............7 1.5 Marking and sealing ......................... -
Page 3: Introduction
INTRODUCTION This operating manual (hereinafter referred to as the OM) covers structure, construction, specifications of LCD display type MV-1901F (hereinafter referred to as the Product), its components and instructions required for the device’s correct and safe operation (intended use, technical service, current repair), as well as disposal information for its components. -
Page 4: Description And Operation Of The Product
Operating Manual 1 DESCRIPTION AND OPERATION OF THE PRODUCT 1.1 D ESCRIPTION The Product is a multipurpose device which displays textual, graphic and other data as a component of navigation and automation systems, security video surveillance, etc. 1.2 T ECHNICAL SPECIFICATIONS 1.2.1 Main parameters technical... - Page 5 LCD display MV-1901F 1.3.2 General description The Product is manufactured in metal casing, where a power connector, audio port and video ports are generally located, see Figure 8. For the description of connectors, see Table 2. Electrical connectors pinouts are represented in Tables 3 –...
- Page 6 Operating Manual Table 6 – Description of DB-15F Pin № Type Description Green Blue Not used common (GND) GND_Red GND_Green GND_Blue + 5 V data (SDA) HSYNC (pinout of unit from side of VSYNC cable connection) Data sync (SCL) Table 7 – Description of DVI-I connector pins Pin №...
-
Page 7: Measurement Tools, Instruments And Appliances
LCD display MV-1901F 1.3.3 Controls and indication of MV-хх04, MV-хх05 type Controls, indication (LEDs) are also located on the switching card, see Figure 2. Figure 2 – Layout of controls, indication (LEDs) on the front panel of the Product 1.4 M... -
Page 8: Intended Use
Operating Manual 2 INTENDED USE 2.1 O PERATIONAL CONSTRAINTS The Product’s installation site must be selected according to the operational constraints (operating temperature and protection degree). CAUTION! Installation site of the Product must not be less than 1 m from a magnetic compass 2.2 P REPARATION FOR THE RODUCT... -
Page 9: Usage Of The Product
LCD display MV-1901F press «Power» button on the front panel; adjust display brightness using brightness controls on the front panel of the Product. Switching the Product off is carried out in the following order: switch off power supply using software tools, transfer circuit breakers of main power switchboard to «OFF»... -
Page 10: Technical Service Of The Product
Operating Manual 3 TECHNICAL SERVICE OF THE PRODUCT 3.1 G ENERAL INSTRUCTIONS Technical Service of the Product (hereinafter – the TS) must be provided by staff, acquainted with its structure, composition and operational features. To ensure reliable operation of the Product service personnel shall carry out all types of service: –... -
Page 11: Preservation
LCD display MV-1901F Table 10 – CL № 1. Visual check Man-hours per 1 To be done Routine Device Visually examine 1 Check completeness and appearance of the Device; 1 person the Product mechanical damage, paint defects must be absent; legends 5 mins are to be read easily;... -
Page 12: Installation And Disassembly On The Product
Operating Manual 4 INSTALLATION AND DISASSEMBLY ON THE PRODUCT 4.1 G ENERAL DESCRIPTION The Product’s operability is controlled by the display brightness LED located on the front panel, and presence of image on the screen. To test problems, see Table 1212. If trouble shooting cannot be provided, contact manufacturer’s service center. - Page 13 LCD display MV-1901F Table 12 – Possible problems / defects and troubleshooting Problem / defect Possible reasons To do Display’s image No voltage supplied Check power cable connection to the Product absent, brightness LED from power Provide the voltage does not glow.
-
Page 14: Storage
Operating Manual 5 STORAGE The Product must be stored in packaging inside areas complying with the required storage conditions (+5 °С …+ 40 °С) with the concentration of dust, oil, moisture and aggressive impurities in the air within the required limits for the working areas of production facilities. -
Page 15: Transportation
LCD display MV-1901F 6 TRANSPORTATION The Product must be transported in the Manufacturer's transportation package in closed means of transport. Types of shipment: - motor vehicle and railroad transportation in closed means of transport (covered cars, multipurpose containers); - air transportation (in sealed and heated compartments);... -
Page 16: Disposal
Operating Manual 7 DISPOSAL New equipment, the parts of the Product damaged during operation, and any overage equipment must not be disposed as standard household wastes, since they contain the materials suitable for re-use. Decommissioned and non-used components of the Product must be delivered to a special waste disposal center licensed by local authorities. -
Page 17: Warranty
LCD display MV-1901F ARRANTY The Manufacturer is under warranty obligations in case of correct System exploitation according to the OM. In case of incorrect operation or service damage claims are not considered by the Manufacturer. More information about warranty terms you can find on the official site of «NPK Morsvyazavtomatica»...
Need help?
Do you have a question about the MV-1901F and is the answer not in the manual?
Questions and answers