Address List - Delta VFD-EL-W Series User Manual

Chapter 4 Parameters VFD-EL-W


5. Address list

The contents of the available addresses are shown in the following table.
Content
AC motor drive
GGnnH
Parameters
Command
Write only
Fire mode
enabled
Status
monitor
Read only
4-82
Address
GG means parameter group, nn means parameter number. For
example, the address of Pr.04.01 is 0401H. Refer to Chapter 4
Parameters for the function of each parameter. When reading
parameters by command code 03H, only one parameter can be read
at a time.
–
bit 0 1
–
bit 2 3
2000H
–
bit 4 5
–
bit 6 7
–
bit 8 15
2001H Frequency command
bit 0
bit 1
bit 2
2002H
–
bit 3 4
–
bit 6 15
00B: No function
2002H Bit 5 01B: Fire mode enabled (Does not include the running
commands)
Error code:
2100H 0: No error occurred
1: Over-current (oc)
2: Over-voltage (ov)
3: IGBT Overheat (oH1)
4: Reserved
5: Drive overload (oL)
6: Motor overload1 (oL1)
7: Over-torque (oL2)
8: External fault (EF)
9: Over-current during acceleration (ocA)
10: Over-current during deceleration (ocd)
11: Over-current during constant speed (ocn)
12: Reserved
13: Reserved
14: PHL (Phase-Loss)
15: Reserved
Function
00B: No function
01B: Stop
10B: Run
11B: Jog + Run
Reserved
00B: No function
01B: FWD
10B: REV
11B: Change direction
00B: Comm. forced first acceleration/deceleration
01B: Comm. forced second acceleration/deceleration
Reserved
1: E.F. (external fault) ON
1: Reset
1: B.B. ON
Reserved