Product Operation - Royal Sovereign IL-926W Owner's Manual

PRODUCT OPERATION

Before laminating important or unique documents, always test a pouch through the laminator using a similar
document.
Hot/Cold Lamination
1. Place the machine on a flat, sturdy surface and flip the power switch to turn on the machine.
2. Use the setting control switch to toggle between Cold Lamination and Hot Lamination options
ranging from 3-5 Mil.
• For hot lamination, the machine will take approximately 60 seconds to warm-up.
NOTE: Standard temperature setting is based on 20lb/80g/m2 copy paper thickness. When
laminating thicker materials, the temperature may not be high enough. In this case, please
select the 5 Mil film setting.
NOTE: A red light may be visible on Feed In before the product is ready. This is due to the
laminator heating up.
Cold lamination does not require any warm up. As soon as the unit is turned on, it is ready
•
for use.
NOTE: If the machine was previously used in hot mode, allow approximately 25 minutes to
cool down.
3. Place the item to be laminated into the laminating pouch.
For Cold Lamination you need adhesive Cold Laminating or Self-Seal Pouches. To laminate,
•
place the item on the adhesive side of the cold film with the document face down.
4. Insert the pouch film into the front opening of the laminator. Make sure to place the sealed end
of the pouch film in first.
• For Cold Lamination remove the paper liner from the cold film slowly while the document is
being inserted into the machine.
5