Maintenance; General; Hydraulics; Mechanical - Car-O-Liner D20 Instruction Manual

Speed Draw aligner D20
5

Maintenance

5.1

General

5.2

Hydraulics

5.3

Mechanical

(138 03 85 231, rev. 0), 2001-04, GB/US
The draw aligner and its component parts are subject to large amounts of
loading and strain. Therefore, they need regular inspection and replacement
of any worn parts.
Inspection must take place each time the draw aligner is put to use.
Check that the piston rod is undamaged and that there is no leakage.
Check that the locking pins at the cylinder attachment points are undamaged
and that the locking washers are in place and undamaged. Replace where
necessary.
Check that the hose couplings are whole and undamaged and do not leak.
Replace where necessary.
For the hydraulic components, also see the manufacturer’s instructions.
Check that all bolts and screws are tight.
Check the locking wedge for damage and deformations. Replace if necessary.
5 Maintenance
Car-O-Liner AB
5.1