Car-O-Liner D20 Instruction Manual page 17

Car-O-Liner AB
Mounting hole
3.4
2 Place the locking pins so that they run straight through the
cylinder mounting holes and through the big mounting holes on the
draw aligner .
Figure 3.3 Fitting the cylinder with locking pins.
3 Fasten the locking pins by placing one circlip in each track on the
locking pins.
Circlip
Figure 3.4 Placing the circlip on the locking pins.
Note! There are four tracks on the locking pins. Make sure that all four are
secured with a circlip.
3 Installation
Speed Draw aligner D20
Locking pin
(138 03 85 231, rev. 0), 2001-04, GB/US